Stanton DJLab 2.1 User Manual
1.
Start/Stop - Press this button to start or stop the platter.
2. Strobe dots -
The dots around the edge of the platter are used in
conjunction with the light located inside the motor ON/OFF switch. While the
platter is in rotation, the dots help to indicate the speed of rotation. The speed
is lower than the displayed speed (33,45,) when the dots are flowing to the
right. It is higher than the displayed speed (33,45,) when the dots are flowing
to the left. When the strobe is stopped, the platter is rotating at the displayed
speed.
platter is in rotation, the dots help to indicate the speed of rotation. The speed
is lower than the displayed speed (33,45,) when the dots are flowing to the
right. It is higher than the displayed speed (33,45,) when the dots are flowing
to the left. When the strobe is stopped, the platter is rotating at the displayed
speed.
3. Slipmat
4. Center spindle
5. Power on/off
4. Center spindle
5. Power on/off
- On - Rotate right
- Off - Rotate left
- Off - Rotate left
6. Platter revolution speeds
- 33 rpm Press 33
- 45 rpm Press 45
- 45 rpm Press 45
7. Target light - Insert target light to the deck and it will light up.
8. Pitch slider - Use this to change the speed of the platter when the PITCH
indicator is lit.
9. Headshell locking nut - Attach headshell by inserting into the front end of
the tone arm, then turn the locking nut clockwise with the head shell firmly
held horizontally.
10. Tonearm
11. Tonearm clamp and rest - Use this rest for the tone arm and clamp it in
position during transportation.
12. Counterweight - Use this to balance the tonearm and to adjust the stylus
pressure.
13. 45rpm adapter holder - Place the attached 45rpm adapter here.
14. Output L&R - This is the standard analog output (RCA jacks)
which should be connected to a phono input on any DJ mixer.
indicator is lit.
9. Headshell locking nut - Attach headshell by inserting into the front end of
the tone arm, then turn the locking nut clockwise with the head shell firmly
held horizontally.
10. Tonearm
11. Tonearm clamp and rest - Use this rest for the tone arm and clamp it in
position during transportation.
12. Counterweight - Use this to balance the tonearm and to adjust the stylus
pressure.
13. 45rpm adapter holder - Place the attached 45rpm adapter here.
14. Output L&R - This is the standard analog output (RCA jacks)
which should be connected to a phono input on any DJ mixer.
15. GND - Ground.
16. Power cord connector - Used to connect the supplied power cord.
7CONTROL OVERVIEW
10