QSC Audio B SERIES User Manual

WLX0001 rev. B

4.

WL3082 and WL212-sw only: Remove the screws in the rigging bars (three screws on the WL3082; two screws on the
WL212-sw). See Figure 3. These screws may have either TORX or Phillips heads. Apply a dab of Loctite QuickStix 248 to the
thread at the end of each screw. Reinstall and lightly secure the screws using a power drill-screwdriver at its lowest torque
setting.

5.

All models: Use the torque wrench, set to 60 in-lb or 7 N-m, to tighten the screws to the proper torque.

6.

WL2102-w and WL218-sw only: Reinstall the knuckle into the channel, while making sure its orientation is correct (Figure 4).
Fasten the cap head screw to the knuckle.

7.

All models: Repeat steps 1 through 6 with the rigging channel or channels on the other end of the loudspeaker enclosure.

8.

WL2102-w and WL218-sw only: Remove all twelve screws on the input plate/rear rigging point and apply Loctite QuickStix
248.

 

➜ Continued

Continued on next page 

➜

Figure 2. Removing the rigging channel screws. Apply threadlock,
then reinstall and torque them. The WL2102-w has two screws on
each side, while the WL218-sw  and WL3082 have four, and the
WL212-sw has six. On the WideLine 8 cabinets, the anchors of the
rigging pin lanyards must be attached as shown when the screws
are reinstalled.