Mackie DJ Mixer User Manual

d.2 Pr

o DJ Pr

oduc

tion C

ons

ole

This LED lights when 

the reverse switch [49] 
has been activated 
for the crossfader. For 
more details, see the 
discussion of the reverse 
switches on the next 
page.

The crossfader is used 

to fade between the two 
pgm signals in the main 
outputs. When the cross-
fader is all the way to 
the left, pgm 1 is heard 
in the main outs. When 
the crossfader is all the 
way to the right, pgm 
2 is heard. When the 
crossfader knob is in the 
center, the main outs get an even mix of pgm 1 and 2. 

The characteristics of how the crossfader affects the 

audio signal are determined by its corresponding con-
tour control [48] and the reverse switch [49].

The crossfader is a high-quality infinium con-
tact-free optical digital fader, designed to last 
the lifetime of the d.2 Pro with no degradation 

in quality.

You can adjust the tension of the fader movement to 

your specific taste, by following these steps:

1.  Turn off the AC power, and remove the power 

cord from the mixer.

2.  Move the crossfader all the way to the left.
3.  Remove the fader cap (knob) by grasping it 

firmly and pulling straight up.

4.  Use a small slot-head screwdriver to turn the 

screw located through the hole on the left side 
of the crossfader slot.  

 

 

 

Rotate the screw clockwise to tighten the ten-
sion, and rotate the screw counter-clockwise to 
loosen the tension. You might need a flashlight 
to make sure you are lined up on the screw.

5.  Replace the fader cap, and you’re all done.

contact-free

cross-fader