Fostex LM16 User Manual
Model LM16 [Introduction/Overview]
8
• For normal cleaning, use a soft dry cloth.
For stubborn dirt, moisten a cloth in
diluted detergent, wring it out firmly, and
wipe the dirt off.
Then polish with a dry cloth. Never use
solvents such as alcohol, thinner or
benzene, since these will damage the
printing and finish of the exterior.
diluted detergent, wring it out firmly, and
wipe the dirt off.
Then polish with a dry cloth. Never use
solvents such as alcohol, thinner or
benzene, since these will damage the
printing and finish of the exterior.
• When temperature and humidity change
suddenly (for example, when you move the
LM16 from a cold place to a warm place),
moisture condensation may occur to the
display and panel.
In such a case, leave it with the power
turned off for some time until the
moisture evaporates.
LM16 from a cold place to a warm place),
moisture condensation may occur to the
display and panel.
In such a case, leave it with the power
turned off for some time until the
moisture evaporates.
Cleaning the exterior
Condensation
• Fostex is not responsible for any “direct
damage” or “indirect damage” caused by
using the LM16.
using the LM16.
About damage
• Use only a CAT-5 STP cable for connection
between the main unit and the control
unit.
unit.
About CAT-5 cable
<Note>:
Do not connect or disconnect a
CAT-5 cable while the LM16 is powered
on. When you connect or disconnect a
CAT-5 cable, make sure that the LM16 is
powered off.
on. When you connect or disconnect a
CAT-5 cable, make sure that the LM16 is
powered off.