Avaya S8300 User Manual

Page of 370
3
Installing a New G700 with an S8300
Install New Firmware on the G700
Installation and Upgrades for G700 and S8300
145
December 2003
Install New Firmware on the G700
This section describes the procedures to install firmware on the G700 Media Gateway processors and 
media modules.
Verify the Contents of the tftpboot Directory
Before proceeding with the G700 firmware installation, you should check the tftpboot directory on the 
TFTP server to make sure the firmware versions match those listed in the planning documentation. 
Determine Which Firmware to Install on the 
G700
Conduct the following procedure to compare software versions running on the G700 processors and 
media modules with the versions in you planning documents. If the versions do not match, new firmware 
for those components is necessary. 
Determine if new firmware for the P330 stack processor is necessary.
1
At either the P330-1(super)# or P330-1(configure)# prompt, type 
dir
.
The system displays the list of software.
Directory List for P300 Processor
2
Check the version number (ver num) of the EW_Archive file to see if it matches the Release 
Letter. If not, you must upgrade the P330 stack processor.
3
Type 
show image version
The system displays the list of software.
Show Image Version List for P330 Processor
M# file 
ver num  file type 
file location 
file description
-- ---- 
-------  ---------- 
------------- 
----------------
1 module-config  N/A 
Running 
Conf Ram 
Module 
Configuration
1 stack-config 
N/A 
Running 
Conf Ram 
Stack 
Configuration
1  EW_Archive
 
3.8.6 
SW Web Image  NV-Ram 
WEB Download
1  Booter_Image
 3.2.5
SW BootImage  NV-Ram 
Booter Image
Mod     Module-Type                                             Bank  Version
------  -----------                                             ----  -------
3       Avaya G700 Media Gateway 
A   0.0.0
3       Avaya G700 Media Gateway 
B   3.9.0