Avaya S8300 User Manual
3
Installing a New G700 with an S8300
Install New Firmware on the G700
Install New Firmware on the G700
148
Installation and Upgrades for G700 and S8300
December 2003
<filename> is the full path name of the mgp firmware image file, which begins with mgp and will
be similar to the name mgp_8_0.bin.
be similar to the name mgp_8_0.bin.
<tftp_server_ip_address> is the IP address of the S8300. See the following example:
copy tftp mgp-image a mgp_8_0.bin 195.123.49.54.
The screen will show the progress.
5
Type
set mgp bootimage
<bank>
where <bank> is the same letter you entered in the previous
step.
6
At the MG-???-1(configure)#
prompt, type
reset mgp
.
A system prompt asks to confirm the reset.
7
Select
Yes
at the dialog box that asks if you want to continue.
The G700 Media Gateway processor will reset. The LEDs on the G700 Media Gateway and the
Media Modules will flash. These elements will each conduct a series of self-tests. When the LEDs
on the Media Modules are extinguished and the active status LEDs on the G700 Media Gateway
are on, the reset is complete.
Media Modules will flash. These elements will each conduct a series of self-tests. When the LEDs
on the Media Modules are extinguished and the active status LEDs on the G700 Media Gateway
are on, the reset is complete.
8
When the P330-1(super)# prompt appears, type
session mgp.
9
At the MGP-???-1(super)# prompt, type
configure
.
10
Verify that the download was successful when the prompt returns.
Type
Type
show mg list_config
. The system displays the list of software.
Example: Show mg list_config
Install New Firmware on the Media Modules
For upgrades of active media modules, you need to take the media modules out of service before
initiating the upgrade process. To do this, go to a SAT session on the primary controller and issue a
busyout command.
initiating the upgrade process. To do this, go to a SAT session on the primary controller and issue a
busyout command.
NOTE:
Skip this busyout procedure if the media modules are not in service; for example during an
initial installation.
initial installation.
Busyout board (for active media modules)
1
Go to a SAT session on the primary controller and enter the command,
busyout board vx
where x is the slot number of the media module to be upgraded.
SLOT TYPE
CODE
SUFFIX HW VINTAGE FW VINTAGE VOIP FW
---- ------
----- ------ ---------- ---------- -------
V0 G700 DAF1 A
00
230(A)
67
V1
ICC
S8300
A
72 00 N/A
V2 DCP MM712
A
2
58
N/A
V3 ANA MM711
A
2
57
N/A
V4 DS1 MM710
A
1
58
N/A