Avaya S8300 User Manual
4
Installing a New G700 without an S8300
Configure the G700
Installation and Upgrades for G700 and S8300
189
December 2003
Show Call Controller Status Screen
The Gateway will have registered with the primary controller, if present. If the primary controller
is running and has been administered properly, the Registered field says
is running and has been administered properly, the Registered field says
YES
and the H248 Link
Status says
UP
. If the controller is not running, the Registered field says
NO
and the H248 Link
Status says
DOWN
.
Set the LSP Transition Points
You must set the time that the G700 searches, in the event of a network problem, for primary controllers
(for example, additional CLAN connections) with which to register. After this search time has elapsed,
the G700 will search for an LSP with which to register. You must also set the total time the G700 searches
for either a primary controller and an LSP, after which the G700 resets. And finally, you must define how
many primary controllers, from 1 to 4, are in the controller list you just defined.
(for example, additional CLAN connections) with which to register. After this search time has elapsed,
the G700 will search for an LSP with which to register. You must also set the total time the G700 searches
for either a primary controller and an LSP, after which the G700 resets. And finally, you must define how
many primary controllers, from 1 to 4, are in the controller list you just defined.
1
At the MG-001-1(configure)# prompt, type
set mgp reset-times primary-search <search-time>
where <search-time> is the time in minutes that the G700 searches for a primary controller
before looking for an LSP. The range is
before looking for an LSP. The range is
from
1
to
60
.
2
At the MG-001-1(configure)# prompt, type
set mgp reset-times total-search <search-time>
where <search-time> is the time in minutes that the G700 searches for both primary controllers
or LSPs. The range is
or LSPs. The range is
from
1
to
60
.
3
At the MG-001-1(configure)# prompt, type
set mgp reset-times transition-point
<#_of_primary>
where <#_of_primary> is the number of primary controllers in the controller list. If the primary
controller is an S8500 or S8700, the range is
controller is an S8500 or S8700, the range is
from
1
to
4.
If the primary controller is an S8300,
<#_of_primary> must be
1
.
MG-001-1(configure)# show mgc
CALL CONTROLLER STATUS
------------------------------------------
Registered : YES
Active Controller : 135.9.71.95
H248 Link Status : UP
H248 Link Error Code: 0x0
MGC List Management : Static
CALL CONTROLLER STATUS
------------------------------------------
Registered : YES
Active Controller : 135.9.71.95
H248 Link Status : UP
H248 Link Error Code: 0x0
MGC List Management : Static
CONFIGURED MGC HOST DHCP SPECIFIED MGC HOST
-------------------- -----------------------
135.9.71.95 -- Not Available --
- Not Available -- -- Not Available --
- Not Available -- -- Not Available --
- Not Available -- -- Not Available --
-------------------- -----------------------
135.9.71.95 -- Not Available --
- Not Available -- -- Not Available --
- Not Available -- -- Not Available --
- Not Available -- -- Not Available --