Husqvarna HUV4210-EXP User Manual
General Information
2006 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual
Page 11
ý
WARNING
• Use insulated tools when working near batteries or electrical connections. Use extreme
caution to avoid shorting of components or wiring.
All vehicles:
• Wear safety glasses or approved eye protection when servicing the vehicle or battery charger.
Wear a full face shield and rubber gloves when working on or near batteries.
• Do not wear loose clothing or jewelry such as rings, watches, chains, etc., when servicing the
vehicle or battery charger.
GENERAL INFORMATION
This manual features two models: the electric vehicle and the gasoline vehicle. Throughout this manual,
important features unique to each model are highlighted. We urge the owner/operator to read and understand
this manual, and to pay special attention to the features specific to his/her vehicle(s).
FRONT BUMPER AND BRUSH GUARD
The front bumper and brush guard are an important part of the vehicle’s design for correct weight distribution.
These parts are interchangeable, but one or the other must be installed at all times during vehicle operation
to achieve proper balance (Figure 3 and Figure 4). See following WARNING.
ý
WARNING
• Do not operate the vehicle without an installed front bumper or brush guard that is
specifically designed and approved for use on this vehicle. Instability in the vehicle could
cause serious injury or death.
Figure 1 Gasoline Vehicle
Figure 2 Electric Vehicle
FRONT
OF VEHICLE
AS SEEN FROM
PASSENGER SIDE
OF VEHICLE
Remove
negative
cable first.
negative
cable first.
DISCONNECT BATTERY CABLES
BEFORE WORKING ON VEHICLE
P
O
S
NEG
PO
S
NEG
PO
S
NEG
P
O
S
NEG
TOW
RUN
WA
RN
ING
FRONT OF
VEHICLE
Place Tow / Run
switch in TOW
switch in TOW
4
3
2
1
Place TOW/RUN switch in the TOW
position before disconnecting or
connecting battery cables.
Remove negative (–)
cable first.
cable first.