Craftsman 247.77099 User Manual

Page of 52
3
WARNING: 
This symbol points out important safety instructions which, if not followed, could 
endanger the personal safety and/or property of yourself and others. Read and follow all 
instructions in this manual before attempting to operate this machine. Failure to comply with these 
instructions may result in personal injury. When you see this symbol - heed its warning.
WARNING:
 
Engine Exhaust, some of its constituents, and certain vehicle 
components contain or emit chemicals known to State of California to cause cancer 
and birth defects or other reproductive harm.
DANGER
:
 This machine was built to be operated according to the rules for safe operation in this 
manual. As with any type of power equipment, carelessness or error on the part of the operator can 
result in serious injury. This machine is capable of amputating hands and feet and throwing objects. 
Failure to observe the following safety instructions could result in serious injury or death.
TRAINING
1.
Read, understand, and follow all instructions on 
the machine and in the manual(s) before 
attempting to assemble and operate. Keep this 
manual in a safe place for future and regular 
reference and for ordering replacement parts.
2.
Be familiar with all controls and their proper 
operation. Know how to stop the machine and 
disengage them quickly.
3.
Never allow children under 16 years old to 
operate this machine. Children 16 years old and 
over should read and understand the operation 
instructions and safety rules in this manual and 
should be trained and supervised by a parent.
4.
Never allow adults to operate this machine 
without proper instruction.
5.
Keep bystanders, helpers, pets, and children at 
least 75 feet from the machine while it is in 
operation. Stop machine if anyone enters the 
area.
6.
Never run an engine indoors or in a poorly 
ventilated area. Engine exhaust contains carbon 
monoxide, an odorless and deadly gas.
7.
Do not put hands and feet near rotating parts or in 
the feeding chambers and discharge opening. 
Contact with the rotating impeller can amputate 
fingers, hands, and feet.
8.
Never attempt to unclog either the feed intake or 
discharge opening, remove or empty vacuum 
bag, or inspect and repair the machine while the 
engine is running. Shut the engine off and wait 
until all moving parts have come to a complete 
stop. Disconnect the spark plug wire and ground 
it against the engine.
PREPARATION   
1.
Thoroughly inspect the area where the 
equipment is to be used. Remove all rocks, 
bottles, cans, or other foreign objects which could 
be picked up or thrown and cause personal injury 
or damage to the machine. 
2.
Always wear safety glasses or safety goggles 
during operation or while performing an 
adjustment or repair, to protect eyes. Thrown 
objects which ricochet can cause serious injury to 
the eyes.
3.
Wear sturdy, rough-soled work shoes and close-
fitting slacks and shirts. Loose fitting clothes or 
jewelry can be caught in movable parts. Never 
operate this machine in bare feet or sandals. 
Wear leather work gloves when feeding material 
in the chipper chute.
4.
Before starting, check all bolts and screws for 
proper tightness to be sure the machine is in safe 
working condition. Also, visually inspect machine 
for any damage at frequent intervals.
5.
Maintain or replace safety and instructions labels, 
as necessary.
6.
To avoid personal injury or property damage use 
extreme care in handling gasoline. Gasoline is 
extremely flammable and the vapors are 
explosive. Serious personal injury can occur 
when gasoline is spilled on yourself or your 
clothes which can ignite. Wash your skin and 
change clothes immediately.
a. Use only an approved gasoline container.
b. Extinguish all cigarettes, cigars, pipes, and 
other sources of ignition.
c.
Never fuel machine indoors.
d. Never remove gas cap or add while the 
engine is hot or running.
e. Allow engine to cool at least two minutes 
before refueling.
f.
Never over fill fuel tank. Fill tank to no more 
than 1/2 inch below bottom of filler neck to 
provide space for fuel expansion.
g. Replace gasoline cap and tighten securely.
h. If gasoline is spilled, wipe it off the engine 
and equipment. Move machine to another 
area. Wait 5 minutes before starting the 
engine.
SAFETY