Agilent Technologies A.18.00 User Manual
331
Chapter 6, Memory Cards/Mass Storage
Default Mass Storage Locations
Default Mass Storage Locations
Built-in IBASIC Controller
The default mass storage location for the built-in IBASIC Controller is the front
panel memory card slot (mass storage volume specifier ":INTERNAL,4") after
any of the following conditions:
panel memory card slot (mass storage volume specifier ":INTERNAL,4") after
any of the following conditions:
•
power-up
•
initializing RAM with the SERVICE screen’s
RAM Initialize
function
The mass storage location for the built-in IBASIC Controller can be changed
using the MASS STORAGE IS command. Refer to the Instrument BASIC Users
Handbook for further information on the MASS STORAGE IS command.
using the MASS STORAGE IS command. Refer to the Instrument BASIC Users
Handbook for further information on the MASS STORAGE IS command.
Save/Recall Registers
The default mass storage location for the Save/Recall registers is the Test Set’s
internal RAM (no mass storage volume specifier) after any of the following
conditions:
internal RAM (no mass storage volume specifier) after any of the following
conditions:
•
power-up
•
initializing RAM with the SERVICE screen’s
RAM Initialize
function
•
resetting the Test Set using the front-panel PRESET key
•
resetting the Test Set using the *RST GPIB Common Command
The mass storage location for Save/Recall registers can be changed using the
Save/Recall
field in the I/O CONFIGURE screen. The default mass storage
volume specifiers for the Save/Recall register mass storage locations are as
follows:
follows:
•
Internal selection - (no mass storage volume specifier, registers are saved to allocated
RAM space)
RAM space)
•
Card selection (not changeable) - ":INTERNAL,4"
•
RAM selection (not changeable) - ":MEMORY,0,0"
•
Disk selection - the
External Disk Specification
field in the TESTS
(External Devices) screen.