Agilent Technologies A.18.00 User Manual
512
S:\agilent\8920\8920b\PRGGUIDE\BOOK\CHAPTERS\callproc.fb
Chapter 8, Programming the Call Processing Subsystem
Programming the ANALOG MEAS Screen
AFGen1 Freq
This field sets the output frequency of Audio Frequency Generator #1.
for programming command syntax.
AFGen1 To
This field has two subfields:
•
the upper subfield sets the destination port for Audio Frequency Generator #1
•
•
FM
= RF Generator FM modulator
•
AM
= RF Generator AM modulator
•
Audio Out
=
AUDIO OUT
connector on front panel of Test Set
•
the lower subfield sets the:
•
•
FM modulation deviation if upper subfield set to
FM
•
AM modulation depth if upper subfield set to
AM
•
amplitude of audio signal (volts RMS) at the
AUDIO OUT
connector if upper sub-
field set to
Audio Out
For testing mobile stations the upper field is normally set to
FM
and the lower field
set to the desired FM deviation in kHz.
for
programming command syntax.
Amplitude
This field sets the output power of the Test Sets’s transmitter (that is, the output
power of the Test Set’s RF Generator).
power of the Test Set’s RF Generator).
for
programming command syntax.
De-Emphasis
This field is used to select or bypass the 750 uSec de-emphasis filter network used
to condition the audio signal before being analyzed by the Audio Frequency
Analyzer.
to condition the audio signal before being analyzed by the Audio Frequency
Analyzer.
for programming command syntax.
Detector
This field is used to select the type of detector used to measure the amplitude of
the audio signal being analyzed by the Audio Frequency Analyzer.
the audio signal being analyzed by the Audio Frequency Analyzer.
for programming command syntax.