Omega CNI16D User Manual
21
Input Type (Process)
ENTER INPUT TYPE MENU:
Press
a
1) Press
a, if necessary, until CNFG prompt appears.
Press
d
2) Display advances to
INPT Input Menu.
Press
d
3) Display flashes
T.ç, RTD or PROC (Thermocouple, RTD or
Process). If the displayed input type is
PROC, press a to skip to
step 6 (
PROC stops flashing).
PROCESS SUBMENU:
Press
b
4) Scroll through the available selection to
PROC (flashing).
Press
d
5) Display shows
STRD stored message momentarily and then
PROC (not flashing).
Press
d
6) Display flashes previous Process type selection. i.e.
0-10
(see below for Process types selection).
Press
b
7) Scroll through the available Process types to the selection of
your choice.
your choice.
Press
d
8) Display shows
STRD stored message and then advances to
RDG Reading Configuration Menu.
Process Types: 100 mV 1 V
10 V
0 – 20 mA
Display:
0-0.1
0-1.0
0-10
0-20
For 4-20 mA Input select 0-20 mA then adjust the Input/Reading accordingly.
To adjust 4-20 mA input, see example under INPUT/READING submenu. The
factory preset value is 4-20 mA.
To adjust 4-20 mA input, see example under INPUT/READING submenu. The
factory preset value is 4-20 mA.
3.2.5 Reading Configuration
Figure 3.4 Flow Chart for Reading Configuration Menu
It
is required that you put the controller in the Standby Mode for any
configuration change other than Set Points & Alarms.