Taylor 1526 User Manual
To Power your WeatherGuide
™
Base Unit
Your WeatherGuide™ base unit is powered by 2 AAA batteries (not
included).
Your WeatherGuide™ base unit is powered by 2 AAA batteries (not
included).
Remove the battery compartment cover on the back of the unit.
Install 2 AAA batteries. Replace the battery compartment cover.
Important: Power the base unit before installing batteries in the re-
mote sensor, or the units’ transmissions may not properly connect.
Install 2 AAA batteries. Replace the battery compartment cover.
Important: Power the base unit before installing batteries in the re-
mote sensor, or the units’ transmissions may not properly connect.
Remote Sensor
Unscrew the 4 screws securing the remote sensor’s battery compart-
ment cover located on the back of the unit. Install 2 AAA batteries.
(Tip: Lithium batteries are recommended in extremely cold or hot lo-
cations.)
Unscrew the 4 screws securing the remote sensor’s battery compart-
ment cover located on the back of the unit. Install 2 AAA batteries.
(Tip: Lithium batteries are recommended in extremely cold or hot lo-
cations.)
How to Set up Your WeatherGuide
™
System
First, power up the base unit using 2 AAA batteries. Next, install 2 AAA
batteries into the remote sensor.
Place the base unit as close as possible to the remote unit.
batteries into the remote sensor.
Place the base unit as close as possible to the remote unit.
There is a Channel switch in the remote
sensor battery compartment. Move the
switch to Channel 1.
sensor battery compartment. Move the
switch to Channel 1.
Press the “TX” button located inside the
remote sensor battery compartment.This
will send a transmission signal to the base
unit. The red LED Indicator light will flash
when a signal is transmitted.
remote sensor battery compartment.This
will send a transmission signal to the base
unit. The red LED Indicator light will flash
when a signal is transmitted.
3
Move channel switch
to Channel 1
Press theTx button to send
transmission signal to base unit