Tektronix 1502C User Manual

Operating Instructions

1502C MTDR User Manual

Vp is the speed of a signal down the cable given as a percentage of the speed of
light in free space. It is sometimes expressed as a whole number (e.g., 66) or a
percentage (e.g., 66%). On the 1502C, it is the percentage expressed as a decimal
number (e.g., 66% = .66). If you do not know the velocity of propagation, you
can get a general idea from the following table, or use the Help with Cables
section of the Cable Information menu. You can also find the Vp with the
procedure that follows using a cable sample.

Jelly Filled

.64

Polyethylene (PIC, PE, or SPE)

.66

PTFE (Teflon 

R) or TFE

.70

Pulp Insulation

.72

Foam or Cellular PE (FPE)

.78

Semi-solid PE (SSPE)

.84

Air (helical spacers)

.98

1. Obtain a known length of cable of the exact type you wish to test. Attach the

cable to the CABLE connector on the front panel.

2. Pull POWER on.

3. Turn the DIST/DIV to an appropriate setting (e.g., if trying to find the Vp of

a three-foot cable, turn the DIST/DIV to 1 ft/div).

4. Turn the 

n

o

 POSITION control until the distance reading is the same as the

known length of this cable.

5. Turn the Vp controls until the cursor is resting on the rising portion of the

reflected pulse. The Vp controls of the instrument are now set to the Vp of
the cable.