John Deere AC-G7510H User Manual

Operator’s Manual

Operation

OPERATION

Recoil Start
NOTE: Read Operator’s Manual carefully before operating this

unit. Always make sure the unit is level and properly

grounded. Check engine oil before starting.

1. Open fuel valve fuel tank. (See Fig. 3)
2. Turn the idle control switch to the OFF position.

(See Fig. 4)

3. Move choke lever to full choke. If re-starting a warm engine,

the choke should be left in the off position. (See Fig. 5)

4. Turn the engine ignition switch to the ON position.
5. Pull recoil to start engine.
6. Once engine has started, slowly move choke lever to no

choke.

NOTE: When engine fails to start after several attempts, repeat

the starting procedures mentioned above with the choke

lever in the off position.

7. Allow the unit to run for two (2) minute warm-up.
8. Make sure the generator is grounded. See Preparing the

Generator; Grounding Instructions.

9. Turn main breaker to ON position (AC-G6010 units only).
10. Test the GFCI receptacle(s) on the unit. Push the test

button. The reset button should pop out and there should

be no power at the receptacle. Apply a test load or lamp

to each receptacle to verify. IF THE RESET BUTTON DOES

NOT POP OUT, DO NOT USE THE RECEPTACLES(S).

SEE DEALER FOR SERVICE IMMEDIATELY.

11. If GFCI receptacle(s) test correctly, firmly push the reset

button to restore power. A distinctive click should be

heard or felt when this is complete. IF THE

RECEPTACLE(S) DO NOT RESET PROPERLY, DO

NOT USE THE RECEPTACLE(S). SEE DEALER FOR

SERVICE IMMEDIATELY.

12. Turn idle control switch to ON position. Loads can now be

applied to unit.

NOTE: This engine is equipped with a “Low Oil” shutdown

system for engine protection. The engine stops when

the oil level gets too low. The engine will not restart

without adding oil. Refer to Preparing the Generator;

Engine Fuel Capacity for instructions on adding oil.

(Fig. 3)

(Fig. 4)

(Fig. 5)

(Subaru Shown)