Ridgid DP15501 User Manual

The head assembly 

weighs about 80 pounds. To reduce 
the risk of back injury get help to lift 
the head.

1. Locate (2) two 10mm dia. x 12mm long

set screws in loose parts bag.

2. Remove protective bag from head

assembly and discard. Carefully lift head
above column tube and slide it onto col-
umn making sure head slides down over
column as far as possible. Align head
with table and base.

3. Install a set screw in each hole (as indi-

cated) on the right side of the head, and
using a 5mm hex “L” wrench, tighten the
two head lock set screws.