Sony PL-383450 Leaflet
BatteryShip.com
PL-383450 Sony Clie PEG-TJ25/U Battery Installation Instructions
PLEASE NOTE: Patience and care, along with moderate technical and hand tool ability, are required for the successful
replacement of a Clie battery. Excessive force may result in damage to your PDA. The instructions below come with
no warranty or guarantee. By utilizing these instructions, you agree to hold Batteryship.com blameless and unaccountable
for any and all damages, problems, or personal injuries that may or may not arise by your use of these instructions.
Replacing your Clie battery may void any warranty you have on your Clie. Please read all instructions and back up
your data BEFORE replacing the battery.
If your Clie is a different model number, use these instructions as a reference and consult your owner’s manual or a
technician if necessary.
Included Mini Flathead Screwdriver Included Plastic Flathead Screwdriver
Step 1.
Remove the two “Y Head” three pointed screws below the label on
the back of the device, as shown, using the included mini flathead
screwdriver. (Your tools may look different than the picture shown.)
You can also use a “Y Head” screwdriver if you have one. Set the
screws aside for reassembly.
the back of the device, as shown, using the included mini flathead
screwdriver. (Your tools may look different than the picture shown.)
You can also use a “Y Head” screwdriver if you have one. Set the
screws aside for reassembly.
Step 2.
Remove the two Phillips screws from the upper
sides of the device, as shown, using the same mini
flathead screwdriver or a 000 Phillips screwdriver.
Set the screws aside for reassembly.
sides of the device, as shown, using the same mini
flathead screwdriver or a 000 Phillips screwdriver.
Set the screws aside for reassembly.
Step 3.
Use the plastic flathead screwdriver or any small flathead
screwdriver (plastic recommended - metal may scratch) to separate
the back case from the front by CAREFULLY prying around the
device. There are clips on all sides of the device holding the front
and back together. Be careful not to break them when prying.
screwdriver (plastic recommended - metal may scratch) to separate
the back case from the front by CAREFULLY prying around the
device. There are clips on all sides of the device holding the front
and back together. Be careful not to break them when prying.
Step 4.
Lift off the back cover. Remove ONLY the Phillips
screw shown in the picture above, then fold back
the protective copper foil (taking care not to tear or
damage it) so that the battery can be reached.
Set the screw aside for reassembly.
screw shown in the picture above, then fold back
the protective copper foil (taking care not to tear or
damage it) so that the battery can be reached.
Set the screw aside for reassembly.
(Steps 5 and 6 Continued on Back)