Grizzly H8110 User Manual
model h8110 (mfg. since 7/09)
-3-
14. insert the bolts through the left-side leg,
tighten with a 5mm hex wrench, and all other
barrel bolts at this time.
barrel bolts at this time.
15. align the pre-drilled holes in the underside
of the work bench table top (a) with the pre-
drilled holes in the legs.
drilled holes in the legs.
16. place a flat washer (e2) onto each of the
four 2" wood screws (e8). From the table
underside, insert the screws in the pre-drilled
holes, and use a 4mm hex wrench to tighten
the wood screws.
underside, insert the screws in the pre-drilled
holes, and use a 4mm hex wrench to tighten
the wood screws.
17. Using a standard screwdriver, attach the right
(sr) and left (sL) drawer sides to the drawer
backs (sB). then slide the drawer bottoms
(Bp) into the drawer side grooves (
backs (sB). then slide the drawer bottoms
(Bp) into the drawer side grooves (
figure 17)
until they are fully seated in the grooves.
SL
SB
SR
BP
Rotate
with
Screwdriver
to Lock
figure 17. initial drawer assembly.
SF
E1
E5
figure 18. Final drawer assembly.
18. install the drawer fronts (sF) (figure 18), the
handles (e5), the screws (e1), and insert the
drawers into the work bench drawer slides.
drawers into the work bench drawer slides.
20. Keeping the wood block flush with the table
top (
figure 19), drill two
5
⁄
64
" holes 1
7
⁄
16
" deep
through the vise plate mounting holes and
into the wood block.
into the wood block.
21. secure the vise plate to the wood block with
two (e10) #5 x 1
7
⁄
16
"
wood screws (
figure
19). install a cotter pin in the end of the lead-
screw, and bend one pin leg to 90 degrees.
screw, and bend one pin leg to 90 degrees.
22. insert the tail vise wood block into the vise
support block (
figure 20). insert the tail vise
leadscrew through the holes in the wood
block and the vise support block at the edge
of the table.
block and the vise support block at the edge
of the table.
figure 19. table vise installation.
A
G
Flush
Flush
Wood Block
Vise Plate
A
G
Wood Block
Vise Support
Block
Lead Screw
Guide Rod
19. insert the guide rods and leadscrew through
the holes in the wood block (g) (
figure 19).
thread the leadscrew into the vise support
until the wood block is slightly snug against
the table and flush with the table top.
until the wood block is slightly snug against
the table and flush with the table top.
Wood Block
Vise Support
Block
A
J
23. turn the tail vise handle clockwise until the
wood block just touches the table, and attach
the vise plate as outlined in
the vise plate as outlined in
Step 21.
figure 20. tail vise installation.