Grizzly G0794 User Manual
-22-
Model G7943/G7944 (Mfg. 10/02+)
Components and Hardware Needed:
Qty
60W Light Bulb ...................................................1
The Model G7943/G7944 includes a light socket.
When the drill press is shipped from the factory,
a dust plug is installed in the light socket for pro-
tection.
When the drill press is shipped from the factory,
a dust plug is installed in the light socket for pro-
tection.
To install a light bulb in the drill press:
1. Remove the dust plug from the light socket.
2. Install a 60W or smaller light bulb in the loca-
tion shown in
Figure 19.
Light
Figure 19. Light bulb access location.
Light Bulb
Access Here
Test Run
Wear safety glasses
whenever starting or
using machine. Failure
to comply may result in
serious personal injury.
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Once assembly is complete, you are ready to test
run the drill press.
run the drill press.
To test run the drill press:
1. Turn the power supply ON at the main
panel.
2. With your finger poised on the paddle
switch (in case there is a problem), flip the
START button
START button
ON. The drill press should run
smoothly, with little or no vibration or rubbing
noises.
noises.
Investigate and correct for strange or unusual
noises before operating the machine further.
noises before operating the machine further.
If you cannot easily locate the source of a
potential problem, refer to
potential problem, refer to
Troubleshooting
on
Page 35. If you still can't solve the
problem, contact our Technical Support at
(570) 546-9663.
(570) 546-9663.
Use only bulbs that are “safety coated” and
shatter resistant. The bulb will be exposed
at the bottom of the head casting which
helps with illumination. Impacts with a bulb
not “safety coated” may shatter, expos-
ing the electrical filaments and creating an
electrical shock hazard.