Grizzly G0794 User Manual
Model G7943/G7944 (Mfg. 10/02+)
-29-
Figure 29. Depth stop components.
Depth Nut
Jam Nut
Depth
Stop Stud
The Model G7943/G7944 has a depth stop that
allows you to drill repeated non-through holes to
the same depth every time.
allows you to drill repeated non-through holes to
the same depth every time.
The depth stop consists of a stud attached to the
quill with two hex nuts that can be lowered or
raised on the stud so the lower nut (depth nut)
hits a stop bracket when the drill bit is lowered.
The upper hex nut (jam nut) is then used to
tighten against the depth nut to secure it in place
so it doesn't move with repeated operations.
quill with two hex nuts that can be lowered or
raised on the stud so the lower nut (depth nut)
hits a stop bracket when the drill bit is lowered.
The upper hex nut (jam nut) is then used to
tighten against the depth nut to secure it in place
so it doesn't move with repeated operations.
Figure 29 shows the various components of the
depth stop.
depth stop.
Depth Stop
To set the depth stop:
1. Lower the drill bit to the required height.
2. Thread the depth nut down against the stop
bracket.
3. Lower the jam nut against the depth nut.
4. Using wrenches, hold the depth nut in place
and tighten the jam nut against the depth
nut.
nut.
Note: The scale on the depth stop can be recali-
brated if it gets moved or has changed since the
factory setting. Refer to
brated if it gets moved or has changed since the
factory setting. Refer to
Calibrating Depth Stop
on
Page 38 for instructions on how this is done.
Stop
Bracket
The table can raised/lowered, rotated, and tilted
90° left or right. Table adjustment controls are
shown in
90° left or right. Table adjustment controls are
shown in
Figure 30.
Adjusting Table
Figure 30. Table adjustment controls.
Large Lock
Lever
Location Pin Nut
Crank
Lever
Small Lock
Lever
Table Height
1. Loosen the large lock lever.
2. Adjust the height.
3. Lock the large lock lever.
Table Rotation
1. Loosen the small lock lever.
2. Rotate the table as necessary.
3. Lock the small lock lever.
Table Tilt
1. Tighten the location pin nut to draw the loca-
tion pin out of the hole.
Note: The location
pin is friction fit in the hole to lock the table at
0°. When reinstalling, set the table to 0°, back
the nut off, and tap the pin back in the hole.
0°. When reinstalling, set the table to 0°, back
the nut off, and tap the pin back in the hole.
2. Loosen the lock bolt and tilt the table to the
desired angle (make sure the small lock lever
is locked, so the table won't fall out).
is locked, so the table won't fall out).
3. Tighten the lock nut bolt.
Lock Bolt