Grizzly G1199 User Manual

-10-

G1199/G1200 Drill Press

Drill chuck assembly.

The Drill Press chuck and arbor must be mount-
ed in the drill press spindle. The arbor has a #6
Jacobs Taper on one end and a #2 Morse Taper
on the other. The #6 Jacobs Taper fits into the
drill chuck and the #2 Morse Taper fits in the drill
press spindle. The arbor, drill chuck and drill
press spindle fit together by friction fit. To mount
the drill chuck on the drill press:

Thoroughly clean all of the shipping oil or cos-
molene from both ends of the arbor, inside the
drill chuck and the drill press spindle. Use
mineral spirits and a rag.

Slide the arbor into the drill chuck and tap
lightly with a soft hammer or block of wood.

Slide the arbor and chuck into the drill press
spindle and turn it until the tang slips into the
slot in the spindle.

While holding onto the drill chuck, tap lightly
on the bottom of the chuck with a soft hammer
or a block of wood. The drill chuck should now
be quite snug in the drill press. If not, repeat
steps 1-3, making sure all oil or cosmolene is
removed.

Tang