Grizzly G1199 User Manual
G1199/G1200 Drill Press
-13-
Figure 15.
Figure 14.
4.
To tilt the table, loosen the pivot bolt and
remove the locator pin (
remove the locator pin (
Figure 15
). This is
done by tightening the nut until the pin is
extracted from its hole. Tilt the table to the
desired angle (up to 45°) and re-tighten the
pivot bolt. Re-insert the locator pin when
returning the table to zero degrees.
extracted from its hole. Tilt the table to the
desired angle (up to 45°) and re-tighten the
pivot bolt. Re-insert the locator pin when
returning the table to zero degrees.
1.
Adjust the stationary depth to three inches
(see depth setting instructions).
(see depth setting instructions).
2.
Rotate the spindle manually and line up the
internal spindle slot with the slot on the side of
the quill. The end of the drill chuck (the tang)
should be visible through the slot at this point.
internal spindle slot with the slot on the side of
the quill. The end of the drill chuck (the tang)
should be visible through the slot at this point.
3.
Insert the wedge shifter through the slot in the
spindle with the tapered edge facing down.
spindle with the tapered edge facing down.
Figure 16.
4.
When the tapered edge of the wedge shifter
contacts the top of the taper, tap the wedge
shifter lightly with a hammer until the taper
and chuck are loose. Do not allow the taper
and chuck to fall onto the table.
contacts the top of the taper, tap the wedge
shifter lightly with a hammer until the taper
and chuck are loose. Do not allow the taper
and chuck to fall onto the table.
Figure 16.
Removing the chuck.
Chuck Removal