Xantrex Technology 806-1055-02 User Manual
34
Freedom HF Owner’s Guide
Common Problems
Buzz in Audio Equipment
Some inexpensive stereo systems may emit a buzzing noise from
their loudspeakers when operated from the Freedom HF. This
occurs because the power supply in the audio system does not
adequately filter the modified sine wave produced by the inverter.
The only solution is to use a sound system that has a higher quality
power supply.
their loudspeakers when operated from the Freedom HF. This
occurs because the power supply in the audio system does not
adequately filter the modified sine wave produced by the inverter.
The only solution is to use a sound system that has a higher quality
power supply.
Television Reception
When the Freedom HF is operating, it can interfere with television
reception on some channels. If interference occurs, try the
following:
1. Make sure that the chassis ground stud on the Freedom HF is
reception on some channels. If interference occurs, try the
following:
1. Make sure that the chassis ground stud on the Freedom HF is
solidly connected to the ground system of your vehicle or
vessel.
vessel.
2. Make sure that the television antenna provides an adequate
(“snow-free”) signal, and that you are using good quality cable
between the antenna and the television.
between the antenna and the television.
3. Keep the cables between the battery and the Freedom HF as
short as possible, and twist them together with two to three
twists per foot. (This minimizes radiated interference from the
cables.)
twists per foot. (This minimizes radiated interference from the
cables.)
4. Move the television as far away from the Freedom HF as
possible.
5. Do not operate high power loads with the Freedom HF while
the television is on.
Freedom HF InvChg Owners Guide.book Page 34 Tuesday, April 29, 2014 12:10 PM