Zebra Technologies MP User Manual

11

UMAN-Charge

NC series Quad Chargers sequentially charge and/or

condition up to 4 batteries.  Charge time is approximately
one hour per battery depending on battery’s state of charge.
Condition cycle times vary with both the battery’s state of
charge and with each model.

Plug the A.C. line of the charger into an A.C. receptacle.

For MP series printers, connect batteries by sliding them
downward onto battery contact plate as though mounting
them on a printer.  (See illustration below.)

Other printer series use individual cables to charge the

battery packs.  Plug the cables into either the charge jack on
the battery pack, or, in the case of the RP3 printer, the
printer’s charging jack.

Once the batteries are installed

or plugged in the charge cycle

will automatically begin, start-

ing with the first battery con-

nected.  It will sequence left

to right through each in-

stalled battery in turn.  The

“Charge” indicator above

the battery under charge

will light steadily during

charging.