Xantrex Technology TC2 204060 User Manual

8

Truecharge2 Series Battery Charger Owner’s Guide

NOTE: The Truecharge2 Battery Charger is designed to be permanently 
mounted. Figure 4 shows a typical installation with three batteries, a battery 
temperature sensor (BTS) and a remote panel (both optional). It also shows 
the AC and DC wiring and protection devices required for a typical 
installation. Means of over-current protection and disconnection must be 
incorporated into the fixed wiring, in accordance with the electrical code 
that governs each installation. 

The battery charger must be installed by a qualified installer in 
accordance with all applicable local or national installation codes. 
Examples of such codes are the US National Electrical Code (NFPA 70), 
the American Boat & Yacht Council standards E-11 and A-31, and the 
US Coast Guard Electrical Regulations (33CFR183).

Figure 4 Configuration for Normal Loads

1

AC input wiring compartment

2

AC mains source protected by correct size and type of branch 
rated circuit breaker

3

DC negative cable

NOTE: Not to scale. For illustration purposes only.

NOTE: In some jurisdictions a
double-pole breaker may be
required.

TC2 204060 Series BattChg Owners Guide.book  Page 8  Friday, July 8, 2011  11:44 AM