Xantrex Technology 815-2524-02 User Manual
16
Freedom SW 230V Installation Guide
Planning Preparations
Installation Tools and Materials
Tools
You will need the following tools to install the Freedom SW 230V
and the battery temperature sensor.
and the battery temperature sensor.
❐
Wire stripper
❐
Crimping tools for fastening lugs and terminals on DC cables
❐
Phillips screwdriver: #2
❐
Slot screwdriver (6 mm wide blade max)
❐
Needle-nose pliers
❐
Wrench for DC terminals: 15 mm
Materials
You will need the following materials to complete your installation:
❐
Strain-relief clamp(s) for AC cables (not provided): trade sizes are
3/4" (Ø28.3mm) and/or 1" (Ø34.6mm)
3/4" (Ø28.3mm) and/or 1" (Ø34.6mm)
❐
DC battery cables
❐
Lugs for DC cables (for 10 mm stud size)
❐
Copper wire for DC grounding: 8 mm
2
❐
Lugs for DC grounding cable (for M6 stud size)
❐
AC and DC disconnect switches and overcurrent protective
devices and connectors as required. See page 13.
devices and connectors as required. See page 13.
❐
AC output and input wire. See Figure 3 on page 8.
❐
If the AC ground wire is stranded, each ground wire requires a ring
terminal
terminal
❐
Six M6 steel screws or bolts to mount the unit
❐
Inverter drip shield (PN: 808-9004) if mounting in marine
installation
installation
NOTE: For a list of tools and materials required to install the
network, refer to the Xanbus System Installation Guide, which is
available for download at www.xantrex.com.
network, refer to the Xanbus System Installation Guide, which is
available for download at www.xantrex.com.
Freedom SW 3K2K 230V InvChg Install Guide.book Page 16 Friday, June 20, 2014 9:11 AM