Xantrex Technology 815-2524-02 User Manual

975-0697-01-01

39

Installing the Inverter/Charger

Th

is g

u

id

e for use 

by 

qu

alified 

perso

nnel

 o

n

ly.

There are several tests to be performed to verify that the installation 
is successful. These tests will verify that:

•

the Freedom SW 230V works in invert mode

•

the Freedom SW 230V works in charge mode

•

the Freedom SW 230V works in AC bypass mode

If any of the tests fails at any point, go to “Step 7: Performing 
Checks Prior to Initial Start-Up” on page 38 and go through the 
checklist again to check against the installation. Perform the tests 
again. If any test fails again, see the troubleshooting section in the 
Freedom SW 230V Sine Wave Inverter/Charger Owner’s Guide.

1.

Close the DC disconnect switch or the DC circuit breaker to 
supply DC power to the Freedom SW 230V.

Wait for all the lights on the front panel to flash on and off, 
indicating that the unit has successfully initialized (10 to 30 
seconds). 

If the light does not come on, make sure the voltage at the DC 
terminals on the Freedom SW 230V is correct, as described in 
“Step 7: Performing Checks Prior to Initial Start-Up” on page 38.

2.

After initialization, observe that none of the lights on the front 
panel should remain illuminated. 

The Inverter Enable button on the Freedom SW 230V and the optional 
accessories do not disconnect DC or AC input power to the Freedom SW 
230V.

Figure 15 Freedom SW 230V Front Panel

XANBUS INTERFACE

STACKING

CLEAR FAULT

RESET

INVERTER
ENABLE

INVERTER
ENABLED

AC IN

FAULT

GEN

SUPPORT

CHARGING WARNING

Freedom SW 3K2K 230V InvChg Install Guide.book  Page 39  Friday, June 20, 2014  9:11 AM