Pelco C1941M User Manual

Pelco Manual C573M-D (11/03)

41

No power at the unit.

No video source.

No output device (such as
a monitor).

No video source.

No input from keyboard.

No signal from keyboard.

Wrong signal from
keyboard.

Text overlay turned off for
one or all outputs.

Display is set off the
screen.

A character was entered
that is not supported by
the MDA.

Unit not functioning.

No video on any output
channel.

Programming menu not
turning on.

No text overlay on the
video output(s).

MDA does not display
a character that was
sent to it.

Check the power plug and
fuse. (Refer to Figure 2 for
fuse location.)

Check that the video source
is connected. (Refer to
Figure 1.)

Check the connection. Check
that the monitor is turned
on. (Refer to Figure 1.)

Check that the video source
is plugged in and function-
ing. (Refer to Figure 1.)

Check that keyboard is
plugged into COM 1. (Refer
to Figure 1.)

Move joystick right.

Place keyboard into direct
mode. (Refer to the 

Entering

Program Mode 

section.)

Set keyboard to 4800 baud.
(Refer to the 

Set Port

section.)

Check menu for display
options for that camera.
(Refer to the 

Set Camera

Display 

section or 

Set

Display 

section, depending

on programming method.)

In addition, check unit ID
DIP switch settings. (Refer
to the 

Clearing Text Display

on All Channels 

section.)

Check display position in
camera menu. (Refer to the

Set Camera Display 

section

or 

Set Display 

section,

depending on programming
method.)

Refer to Appendix B for a
list of characters supported
by the MDA for display of
titles and message text.