Grizzly G0555/G0555P User Manual
-22-
model g0555/g0555p (mfg. Since 5/11)
figure 24. 4" dust hose attached to dust port.
Dust collection
DO NOT operate this bandsaw without an ade-
quate dust collection system. This bandsaw
creates substantial amounts of wood dust
while operating. failure to use a dust collec-
tion system can result in short and long-term
respiratory illness.
Recommended cfM at Dust Port: 400 cfM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
6. Unlock the blade tracking adjustment knob
so the knob will rotate for adjustments in the
next steps.
next steps.
Note: The blade tracking adjustment knob
controls the tilt of the upper wheel which,
in turn, controls the center tracking of the
blade.
controls the tilt of the upper wheel which,
in turn, controls the center tracking of the
blade.
7. Spin the upper wheel with one hand and use
the blade tracking adjustment knob with the
other hand to make the blade ride in the cen-
ter of the bandsaw wheel tire.
other hand to make the blade ride in the cen-
ter of the bandsaw wheel tire.
8. After the blade consistently rides in the center
of the wheel after several rotations, lock the
blade tracking adjustment knob to secure the
setting.
blade tracking adjustment knob to secure the
setting.
9. Close the upper wheel cover.
Note: For the best performance from your saw,
regularly maintain the proper tracking of the
blade.
regularly maintain the proper tracking of the
blade.
To connect a dust collection hose:
1. Fit the dust hose over the dust port, as shown
in the figure below, and secure in place with a
hose clamp.
hose clamp.
2. tug the hose to make sure it does not come
off.
Note: A tight fit is necessary for proper per-
formance.
formance.