Manitowoc Ice Q-0600 User Manual

10.  Fit tubing provided into the proper place, as shown.  

Make sure that the discharge line ends up on the 
inside of the suction line. Cut ice machine suction 
line to fit new tubing.  Deburr suction line before 
fitting new tubing in. 

 

 

 

 

A.  Cut process tubing approximately 3” from the 

horizontal portion of the tube.  Make sure to cut 
both ends of the tube to make sure that a “T” 
fitting can be placed in between the pieces.  

 

 

 
 

B.  Place “T” fitting in between process tubing and 

place pieces of additional tubing between open 
end of T and HPR valve, as shown below. 

 

 

 

C.  Return to instruction #11. 

11.  Place armaflex insulation provided in kit on suction 

line, as shown in picture below. Slide insulation up 
tubing and secure while brazing. 

12.  Braze all tubing into place.  Purge system with 

nitrogen during all brazing operations on the ice 
machine. 

13.  Use electrical tape to seal suction line insulation. 
 

 

 

14.  Reattach the wiring harness to the compressor. 
 

 

 
15.  Replace the filter/dryer before evacuating the 

machine.  Make sure that filter/dryer tubing is not 
rubbing against the compressor. 

16.  Evacuate machine to 500 microns. 
17.  Charge the machine with nameplate charge. 
18.  Make sure that all tubing is not rubbing against 

anything else in the machine.   

19.  Reinstall corner post that was removed earlier and 

place electrical cover on compressor. 

20.  Reinstall back panels of ice machine. 
 
 
 
 
 
 
 
 
 
 

8006173 

Sheet 2 of 3 

06/25/01 

Horizontal 
Portion 

Approx. 3”