Tektronix TDS460A User Manual
TDS Family Oscilloscope Programmer Manual
D–1
Appendix D: Factory Initialization Settings
The factory initialization settings provide you a known state for the digitizing
oscilloscope.
oscilloscope.
Factory initialization sets values as shown in Table D–1.
Table D–1: Factory Initialization Settings
Control
Changed by Factory Init to
Acquire mode
Sample
Acquire repetitive signal
TDS 400A, 510A, 500C, & 700C: ON
(Enable ET)
(Enable ET)
Acquire stop after
RUN/STOP button only
Acquire # of averages
16
Acquire # of envelopes
10
Channel selection
Channel 1 on, all others off
Cursor H Bar 1 position
10% of graticule height
(–3.2 divs from the center)
(–3.2 divs from the center)
Cursor H Bar 2 position
90% of the graticule height
(+3.2 divs from the center)
(+3.2 divs from the center)
Cursor V Bar 1 position
10% of the record length
Cursor V Bar 2 position
90% of the record length
Cursor amplitude units
Base
Cursor function
Off
Cursor mode
Independent
Cursor time units
Seconds
Date and time
No change
Delay events,
triggerable after main
triggerable after main
TDS 400A: 1
TDS 510A, 500C, 600B, & 700C: 2
TDS 510A, 500C, 600B, & 700C: 2
Delay time,
delayed runs after main
delayed runs after main
TDS 400A: 10 ns
TDS 510A, 500C, 600B, & 700C: 16 ns
TDS 510A, 500C, 600B, & 700C: 16 ns
Delay time,
delayed triggerable after main
delayed triggerable after main
TDS 400A: 60 ns
TDS 510A, 500C, 600B, & 700C: 16 ns
TDS 510A, 500C, 600B, & 700C: 16 ns
Delay trigger average #
16
Delay trigger envelope #
10
Delayed, delay by ...
Delay by Time