Panasonic EY6950 User Manual

Page of 12
- 9 - 
 
extremely  short  after  recharging, 
replace the battery pack with a new 
one.
Note:  Use under extremely hot or 
cold  conditions  will  reduce 
operating capacity per charge.
Charging
Note:  When  you  charge  the  battery 
pack for the first time, or after 
prolonged  storage,  charge  it 
for about 24 hours to bring the 
batteries up to full capacity.
EY0110
 1. Plug the charger into the AC outlet.
Note:  Sparks  may  be  produced 
when the plug is inserted into 
the AC power supply, but this 
is  not  a  problem  in  terms  of 
safety.
 2. Insert the battery pack firmly into the 
charger.
Battery pack
To AC 
outlet
Battery 
charger
 3. During charging, the charging lamp 
will be lit.
   When charging is completed, an inter-
nal electronic switch will automatically 
be triggered to prevent overcharging.
 Charging will not start if the battery 
pack is warm (for example, immedi-
ately after heavy-duty operation).
  The orange standby lamp will be 
lit  until  the  battery  cools  down.  
Charging will then begin automati-
cally.
 4. When  charging  is  completed,  the 
charging  lamp  will  start  flashing 
quickly.
 5. When in any of the conditions that 
battery pack is too cool, or the battery 
pack has not been used for a long 
time, the charging lamp is lit.
   In this case, charging takes longer to 
fully charge the battery pack, than the 
standard charging time.
 If  a  fully  charged  battery  pack  is 
inserted  into  the  charger  again, 
the  charging  lamp  may  light  up 
and  then  flash  slowly. After  sev-
eral  minutes,  the  charging  lamp 
may  flash  quickly  to  indicate  the 
charging is completed.
 6. If the charging lamp does not light 
immediately  after  the  charger  is 
plugged in, or if after the standard 
charging time the lamp does not go 
off, consult an authorized dealer.
Note:    When charging a cool battery 
pack (below 5°C (41°F) in a 
warm place, leave the battery 
pack at the place and wait for 
more than one hour to warm 
up the battery to the level of 
the  ambient  temperature.  
Otherwise battery pack may 
not be fully charged.
 
  Cool down the charger when 
charging more than two bat-
tery packs consecutively.
 
  Do not insert your fingers into 
contact hole, when holding 
charger or any other occa-
sions.
CAUTION:   Do not use power source 
from an engine generator.
 
 Do not cover vent holes 
on  the  charger  and  the 
battery pack.