Grizzly G0704 User Manual

model g0704 (mfg. since 09/09)

-29-

Drill chuck

figure 28. snugging the drawbar.

5. hold the chuck with one hand and finish loos-

ening the drawbar until the chuck falls out of
the spindle.

Note:  The  chuck  is  attached  to  the  arbor
using  a  B-16  taper.  This  attachment  is  con-
sidered to be semi-permanent. There should
be  no  need  to  remove  the  chuck  from  the
arbor.

4. use a 17mm wrench to prevent the spindle

from  turning  while  you  use  an  8mm  wrench
to  loosen  the  drawbar  2–3  turns.  do  not
continue loosening the drawbar without sup-
porting  the  drill  chuck  or  it  will  fall  from  the
spindle.

To remove the chuck and arbor from the

spindle:

1. disConneCt mill/drill From poWer!

2. remove the drawbar cap.

3. lock the quill in place with the quill lock

lever.

To install the drill chuck and arbor:

1. disConneCt mill/drill From poWer!

2. remove the drawbar cap.

3. insert the chuck arbor into the spindle, mak-

ing sure to line up the slot in the arbor with
the pin in the spindle.

4. thread the drawbar into the arbor until the

arbor is seated up into the spindle taper.

5. use a 17mm wrench to prevent the spindle

from turning while you use an 8mm wrench
to snug the drawbar, as shown in

figure 28.

NOTICE

The Model G0704 drawbar will extract the

arbor from the spindle. Once the arbor or

collet has broken free from the spindle

taper, be sure to properly support it while

continuing to loosen the drawbar. failure

to properly support the arbor or collet

while loosening the drawbar will result in

the arbor or collet falling out of the spindle,

causing damage to machine components.

Note: Do not overtighten the drawbar.

Overtightening makes arbor removal difficult
and will damage the arbor and threads.

6. re-install the drawbar cap.