Yamaha 3-axis model User Manual
6-1
Chapter 6 PXYX
1
Installation
WARNING
Always turn the controller power OFF before installing the robot. Serious
accidents might occur if the robot starts to operate during installation.
accidents might occur if the robot starts to operate during installation.
To install the PXYX robot, tap holes into the installation base and secure the
robot to the base with M4 bolts from the inside of the robot.
robot to the base with M4 bolts from the inside of the robot.
1-1
Installation bolt types
• Use the following type of installation bolt.
Hexagon socket head Cap screw M4 Strength 8.8T
1-2
Installation bolt nominal length
!
CAUTION
Do not use washers or spring washers with the tightening bolt.
The bolt head could interfere with the linear guide's bearings and be damaged.
The bolt head could interfere with the linear guide's bearings and be damaged.
If the installation base is made of steel, secure 1D or more (4mm or more for M4)
for the screw fitting length. When using aluminum, secure 1.5D or more (6mm or
more for M4). The rail thickness is 5mm. (Refer to Fig. 6-1.)
for the screw fitting length. When using aluminum, secure 1.5D or more (6mm or
more for M4). The rail thickness is 5mm. (Refer to Fig. 6-1.)
Recommended nominal length
When installation base is made of steel
10mm or more
When installation base is made of aluminum
12mm or more
9.5
(42)
φ8
4.5
φ4.5
Fig. 6-1
1-3
Tightening torque
• The accurate tightening torque will differ according to the seating face fric-
tional coefficient and the female screw material, etc. The following tightening
torque is recommended as a guide.
Recommended torque
torque is recommended as a guide.
Recommended torque
2.9N·m to 4.4N·m (30kgf·cm to 45kgf·cm)