Lincoln Electric SVM141-A User Manual

If for any reason you do not understand the test procedures or are unable to perform the test/repairs safely, con-
tact the Lincoln Electric Service Department for electrical troubleshooting assistance before you proceed.  Call
216-383-2531 or 1-800-833-9353.

The machine welds at a very high
output regardless of the current
control setting.

1.  If welding in the TIG mode, the

remote control device may be
defective.

1.  Perform the 

2.  Perform the 

3.  Check the current control for

proper operation.  Normal resis-
tance is 10,000 ohms.  See the
Wiring Diagram.

4.  Check leads #221 and #222

between the output shunt and
the control board.  See the
Wiring Diagram.

5.  The control board may be faulty.

Accessories plugged into the 115
volt receptacle do not work.  (220
VAC receptacle on European mod-
els only).

1.  Make sure the accessory, plug

and associated leads are in
good working condition.

2.  Make certain the correct input

voltage is being applied to the
machine.  (The reconnect lead
must be in the correct position.)

3.  The circuit breaker may be

tripped.  Reset if necessary.

1.  The circuit breaker (CB) may be

faulty.

2.  Check the receptacle and asso-

ciated leads for loose or faulty
connections.

3.  Perform the