IBM 9077 User Manual

IBM 9077 SP Switch Router: Get Connected to the SP Switch

ibmSPDepSwTokenA combination of switch_number, switch_chip and 

switch_chip_port attributes from the 
DependentNode class.

ibmSPDepSwArpThe arp_enabled attribute in the Switch_partition class.

ibmSPDepSwNodeNumberThe switch_node_number attribute in the 

DependentNode class.

ibmSPDepIPaddrThe netaddr attribute in the DependentAdapter class.

ibmSPDepNetMaskThe netmask attribute in the DependentAdapter class.

ibmSPDepIPMaxLinkPktThe switch_max_ltu attribute in the Switch_partition 

class.

ibmSPDepIPHostOffsetThis attribute stores the difference between the host 

portion of a node’s IP address and its 
corresponding switch node number. When ARP 
is disabled on the SP Switch network, this offset 
is subtracted from the host portion of the IP 
address to calculate the switch node number.

ibmSPDepConfigStateThe six config states of the dependent node are: 

notConfigured, firmwareLoadFailed, 
driverLoadFailed, diagnosticFailed, 
microcodeLoadFailed, and fullyConfigured, for 
use in configuring the adapter.

ibmSPDepSysNameThe syspar_name attribute in the Syspar class.

ibmSPDepNodeStateThe value of nodeUp or nodeDown, to show the status 

of the dependent node.

ibmSPDepSwChipLinkThe switch_chip_port attribute in the DependentNode 

class.

ibmSPDepNodeDelayThe switch_link_delay attribute in the Switch_partition 

class.

ibmSPDepAdminStateThe value of up, down, or reconfigure, indicating the 

desired state of the dependent node. If the 
dependent node is not in its desired state, the 
SNMP agent on the GRF will trigger the 
appropriate action to change its state.

Figure 25 shows a single-frame RS/6000 SP in a single partition with a 
connection to the GRF. Nodes 1 and 2 are installed with PSSP 2.4. The other 
nodes are installed with any other version of PSSP that can coexist with