Muratec F-112 User Manual

S

PECIFICATIONS

For the best result, use conventional 75 g/m

2

 (20 lb) paper. Ensure that the paper is of good quality, 

and free of cuts, nicks, tears, spots, loose particles, dust, wrinkles, voids, and curled or bent edges.

If you are unsure of what type of paper you are loading, such as bond or recycled paper, check the 
label on the package.

The following problems may cause print quality deviations, jamming or even damage to the 
machine:

: 

• Do not use letterhead paper printed with low-temperature inks, such as those used in some types of 

thermography.

• Do not use raised or embossed letterhead.
• The machine uses heat and pressure to fuse toner to the paper. Insure that any colored paper or 

preprinted forms use inks that are compatible with this fusing temperature (200 °C or 392 °F for 0.1 

second).

Poor print quality or toner 
adhesion, problems with 
feeding

Too moist, too rough, too 
smooth or embossed; faulty 
paper lot

Try another kind of paper, 
between 100 ~ 400 Sheffied, 4 
~ 5 % moisture content.

Dropout, jamming, curl

Stored improperly

Store paper flat in its moisture-
proof wrapping.

Increased gray background 
shading/machine wear

Too heavy

Use lighter paper, use the rear 
output slot.

Excessive curl problems 
with feeding

Too moist, wrong grain 
direction or short-grain 
construction

Use the rear output slot.
Use long-grain paper.

Jamming, damage to 
machine

Cutouts or perforations

Do not use paper with cutouts or 
perforations.

Problems with feeding

Ragged edges

Use good quality paper.

Acid Content

5.5 pH or lower

Caliper

0.094 ~ 0.18 mm (3.0 ~ 7.0 mils)

Curl in Ream

Flat within 5 mm (0.02 in.)

Cut Edge Conditions

Cut with sharp blades with no visible fray.

Fusing Compatibility

Must not scorch, melt, offset or release hazardous 
emissions when heated to 200 °C (392 °F) for 0.1 
second.

Grain

Long Grain

Moisture Content

4 % ~ 6 % by weight

Smoothness

100 ~ 400 Sheffied