Metrologic Instruments MLPN 2168 User Manual

The scanner can be positioned in a vertical orientation with the Metrologic stand (Part #45478). 
To attach the unit to the stand and work surface purchase the following: four 6-32 x ½" 
(maximum length) machine screws and two (2) #10 pan head or two (2) #8 countersunk wood 
screws. (Refer to figure 1) 

1.   Lay the scanner face down on a clean cloth to prevent any scratches from occurring 

on the output window.  Position the scanner so the red and green LEDs are pointed 
toward you. 

2.   Lay the stand on the scanner with the angled bracket pointing up and toward you. 

3.   Align the four clearance holes to the four holes in the scanner’s case.  Fasten the 

scanner to the stand by inserting the four 6-32 x ½" screws into the four holes in the 
scanner’s case. 

4.   Drill two holes into the work surface that correspond with the holes in the  

216mm - 96mm (8.5" x 3.80") base of the stand.  

5.   Use two pan head or countersunk wood screws to attach the scanner and stand to the 

work surface. 

5.00 in. 

3.50 in. 

1.90 in. 

3 

4 & 5 

2 

1 

Figure 1:  Stand Installation 

5