Sharp MXC250 User Manual

These settings are used to configure settings for 
hardware functions of the machine. To access one of 
these settings, select "Device Control" in the mode 
selection screen, select the desired setting in the 
device control screen, and press the [OK] key.

The temperature of toner fusing is controlled according 
to the weight of the paper that is used.

Use this function to clean the machine's fusing unit 
when dots or other dirt appear on the printed side of 
the paper. When this function is executed, "V" printed 
paper is output and the fusing unit is cleaned. 

If the colors are out of place on the printed surface 
when color printing is performed, the print positions of 
the colors can be adjusted. 
Select "Registration Adj." and press [OK] key to start 
automatic registration. When appearing the complete 
message, the adjustment is completed.

These settings are used to configure various settings 
related to the operation panel. To access one of these 
programs, select "Operation Setting" in the mode 
selection screen, select the desired setting in the 
operation setting screen, and press the [OK] key.

This function returns the copy settings to the default 
settings if the operation panel is not used for the 
duration of time set with this setting following the end 
of a copy job. Time selections are "0 sec.", "10 sec.", 
"20 sec.", "60 sec.", "90 sec." and "120 sec.".
The factory default setting is 60 seconds.
Select "Auto Clear" and press the [OK] key. The 
following screen will appear.

Select the desired time with the [

] or [

] key.

If you do not want auto clear to operate, select "0".

This setting is used to select whether or not the display 
will automatically return to the base screen if no keys 
are pressed on the operation panel for one minute in 
scan or fax mode.
The factory default setting is automatic return to the 
base screen.

This setting is used to select the display language.
Select "Language Setting", press the [OK] key, and 
follow the steps below.

This setting is used to set the length of time that 
messages appear in the display (this applies to 
messages that appear for a certain length of time and 
then automatically disappear.) 
Select from "Short (3 sec.)", "Normal (6 sec.)", or 
"Long (9 sec.)".
The factory default setting is "Normal (6 sec.)".

• Be sure to use only paper that is in the 

same weight range as the weight range 
set here. Do not mix in other standard 
paper that differs from the set range.

• When settings are changed, the changes 

will take effect after the machine is 
restarted. To restart the machine, see 
"POWER ON AND OFF" (p.15).

If improvement is not noticed after the first 
time you use the function, try executing the 
function again.

Depending on the machine's condition, 
adjustment error message may appear. 
In that case, execute the registration 
adjustment again.

The Auto Clear function is disabled when 
scanned data is stored under the following 
status: When the last page has not been 
scanned during the 2 IN 1 or 4 IN 1 copy 
process (one page has been scanned for a 
two-page set or three pages have been 
scanned in a four-page set), or only one 
side has been scanned in the ID card copy 
process.