Panasonic KX-MB3150CX User Manual
Important Information
4
Important Information
Important Information
For your safety
Laser radiation
LED light
Fuser unit
Note:
L
The area near the recording paper exit (
2) may also
get warm. This is normal.
For best performance
Toner cartridge and drum cartridge
L
When replacing the toner cartridge or drum
cartridge, do not allow dust, water, or liquids to come
in contact with the drum. This may affect print quality.
cartridge, do not allow dust, water, or liquids to come
in contact with the drum. This may affect print quality.
L
For optimal performance, genuine Panasonic toner
cartridges and drum cartridges are recommended.
We cannot be responsible for problems that may be
caused by a non-Panasonic toner cartridge or drum
cartridge:
–
cartridges and drum cartridges are recommended.
We cannot be responsible for problems that may be
caused by a non-Panasonic toner cartridge or drum
cartridge:
–
Damage to the unit
–
Poor print quality
–
Improper operation
Toner cartridge
L
Do not leave the toner cartridge out of the protective
bag for a long time. It will decrease the toner life.
bag for a long time. It will decrease the toner life.
Drum cartridge
L
Read the instructions on page 13 before you begin
installation of the drum cartridge. After you have read
them, open the drum cartridge protective bag. The
drum cartridge contains a photosensitive drum.
Exposing it to light may damage the drum. Once you
have opened the protective bag:
–
installation of the drum cartridge. After you have read
them, open the drum cartridge protective bag. The
drum cartridge contains a photosensitive drum.
Exposing it to light may damage the drum. Once you
have opened the protective bag:
–
Do not expose the drum cartridge to light for
more than 3 minutes.
more than 3 minutes.
–
Do not touch or scratch the black drum surface.
–
Do not place the drum cartridge near dust or dirt,
or in a high humidity area.
or in a high humidity area.
–
Do not expose the drum cartridge to direct
sunlight.
sunlight.
L
To extend the life of the drum cartridge, the power
switch should never be turned OFF immediately after
printing. Leave the power turned ON for a minimum
of 30 minutes after printing.
switch should never be turned OFF immediately after
printing. Leave the power turned ON for a minimum
of 30 minutes after printing.
CLASS 1 LASER PRODUCT
The printer of this unit utilises a laser. Use of
controls or adjustments or performance of
procedures other than those specified
herein may result in hazardous radiation
exposure.
controls or adjustments or performance of
procedures other than those specified
herein may result in hazardous radiation
exposure.
Laser diode properties
Laser output : Max. 6.5 mW
Wavelength : 760 nm – 800 nm
Emission duration : Continuous
Laser output : Max. 6.5 mW
Wavelength : 760 nm – 800 nm
Emission duration : Continuous
CLASS 1M LED PRODUCT
Do not view directly with optical instruments.
LED light of CIS properties
LED radiation output : Max. 1 mW
Wavelength : Red 630 nm typ.
LED radiation output : Max. 1 mW
Wavelength : Red 630 nm typ.
Green 520 nm typ.
Blue 465 nm typ.
Blue 465 nm typ.
Emission duration : Continuous
During or immediately after printing, the
fuser unit (
fuser unit (
1) gets hot. This is normal. Do
not touch the fuser unit.
1
2