Panasonic DP-C106 User Manual
Basic Copying
15
Positioning the Originals
There are two ways to position originals on the DP-C106: on the Document
Glass or in the ADF.
Glass or in the ADF.
The Document Glass
Perform the following steps to use the Document Glass:
1.
1.
Raise the ADF.
2.
Align the original into the rear, left-hand corner of the Document Glass
face
face
down. Place your original in the same orientation that the paper is
loaded in your selected Paper Tray.
For transparency sheets, tracing paper or other types of thin paper, place a
blank, white sheet over the original on the Document Glass.
blank, white sheet over the original on the Document Glass.
For information on the Paper Supply button, see Chapter 3, “Copy
Features”. For information on loading paper into a Paper Tray, see "Setting
Up the DP-C106" in Installation Instructions.
Features”. For information on loading paper into a Paper Tray, see "Setting
Up the DP-C106" in Installation Instructions.
3.
Close the ADF.
CAUTION
When copying a thick document, do not force the ADF down. The Document
Glass may break if under too much pressure.
Glass may break if under too much pressure.
WARNING
If you must perform a copy operation with the ADF open, do not look at the
scanner light.
The maximum original size that the Document Glass can scan is 11 inch x 17
inch or A3 (297 mm x 420 mm).
scanner light.
The maximum original size that the Document Glass can scan is 11 inch x 17
inch or A3 (297 mm x 420 mm).
If you should try to register an original document larger than the maximum
size on the ADF, the image will be cut off on your copy output.
size on the ADF, the image will be cut off on your copy output.
Long Edge Feed (LEF)
Short Edge Feed (SEF)