Xerox DC230LP User Manual
7
+(
'
2&80(17
&
203$1<
DC230LP Windows NT
®
4.0 TCP/IP Quick Install
Page 2 of 4
e)
Press [Enter].
**SAVED**
displays
momentarily, followed by
.
7.
Enter the Subnet Mask:
a)
Press [
] until
displays.
b)
Press
[
].
displays.
c)
Use the [
] or [
] key to select the
first digit of the Subnet Mask for your
network.
network.
d)
Press [
] to move to the next digit.
Repeat this procedure to enter the
entire Subnet Mask.
entire Subnet Mask.
e)
Press [Enter].
**SAVED**
displays
momentarily, followed by
.
8.
Enter the Broadcast Address:
Note: Broadcast Address is where all the host
bits are set to either zeros (0) or ones (1).
bits are set to either zeros (0) or ones (1).
Default Gateway
(your entry)
(your entry)
>
Subnet Mask
(current entry)
(current entry)
>
Subnet Mask
=
(current entry)
Subnet Mask
(your entry)
(your entry)
>
a)
Press [
] until
displays.
b)
Press [
].
displays.
c)
Use the [
] or [
] key to select the
first digit in the Broadcast Address.
d)
Press [
] to move to the next digit.
Repeat procedure to enter the entire
Broadcast Address.
Broadcast Address.
e)
Press [Enter].
**SAVED**
displays
momentarily, followed by
.
9.
Enter the Printer (Host) Name:
Note: It is recommended that the Printer (Host)
Name be the same as your Share Name.
Name be the same as your Share Name.
a)
Press [
] until
displays.
b)
Press
[
].
displays.
c)
Press [
] repeatedly until the cursor
reaches the last character. A tone
sounds indicating when the last
character has been reached.
sounds indicating when the last
character has been reached.
Broadcast Addr
(current entry)
(current entry)
>
Broadcast Addr
=
(current entry)
Broadcast Addr
(your entry)
(your entry)
>
Printer Name
(current entry)
(current entry)
>
Printer Name
=
(current entry)
b)
Press [
].
displays.
c)
Press [
] until the required setting
displays .
d)
Press
[Enter].
**SAVED**
displays
momentarily, followed by
.
6.
Enter the Gateway Address:
a)
Press [
] until
displays.
b)
Press [
].
displays.
Note: Use zeros to supplement each address
segment if fewer than 3 digits are used; e.g.,
13.252.25.08 = 013.252.025.008.
segment if fewer than 3 digits are used; e.g.,
13.252.25.08 = 013.252.025.008.
c)
Use the [
] or [
] key to select the
first digit in the Gateway Address.
d)
Press [
] to move to the next digit.
Repeat this procedure to enter the
entire Gateway Address.
entire Gateway Address.
RARP
=
(current entry)
*
RARP
=
(required entry)
RARP
(your entry)
(your entry)
>
Default Gateway
(current entry)
(current entry)
>
Default Gateway =
(current entry)
(current entry)