Xerox 7232 User Manual

NOTE: Select [Enabled] when the machine is connected to a network on which IPv6 
stateless address autoconfiguration is disabled, or when you want to set a static IPv6 
address.

If you selected [Enabled] in step 4, proceed to step 5. Otherwise, proceed to step 11.

Select [IPv6 – Manual IP Address Setup], and then [Change Settings].

Use the keypad on the screen to enter the IP Address for the machine in the 
format “xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx”. Select [Save].

Select [Manually Configured IPv6 Prefix], and then [Change Settings].

Set the IP address prefix, and then select [Save].

Select [IPv6 – Manual Gateway Setup], and then [Change Settings].

Using the same method as in step 6, set the gateway address.

Select [IPv6 – IP Filter], and then select [Enabled] or [Disabled].

NOTE: If you do not wish to use the IP filter feature, select [Disabled].

NOTE: Use CentreWare Internet Services to register the IP addresses which are not 
allowed to access the machine. 

When you have finished establishing TCP/IP, select [Close] on the [Protocol 
Settings] screen.

Install the print driver on the NetWare client computer. Refer to the HTML document in 
PCL Print Driver CD-ROM.

Make sure that the machine has been installed on the network correctly by submitting 
a test print from each client workstation. Perform the following steps.

Open a document on a client workstation.

Select the machine as the printer.

Print the document on the machine and verify that it prints correctly.

Make sure that the print driver is installed on every workstation that will be sending 
jobs to the machine.

Repeat the test for all workstations that will be sending jobs to the machine.

The installation process is now complete.

If the test print fails, refer to the Problem Solving chapter for assistance.