Xerox 7232 User Manual

Press the <Machine Status> button on the control panel, and then select the 
[Tools] tab on the screen.

Select [Connectivity & Network Setup]. 

Select [Protocol Settings].

Under [TCP/IP - IP Mode], select [IPv4 Mode], [IPv6 Mode] or [Dual Stack].

Select [IP Address Resolution], and then [Change Settings].

Select a method for establishing an IP address from [DHCP], [BOOTP], [RARP], 
[DHCP/Autonet], and [STATIC], and then select [Save].

NOTE: Use the DHCP server together with the Windows Internet Name Server 
(WINS) server.

If you selected [STATIC] in step 7, then proceed to step 8 to configure the protocol 
settings. Otherwise, proceed to step 14.

Select [IPv4 - IP Address], and then [Change Settings].

Use the keypad on the screen to enter the IP Address for the machine in the 
format “xxx.xxx.xxx.xxx”. When you have finished entering all values, select 
[Save].

Select [IPv4 – Subnet Mask], and then [Change Settings].

Using the same method as in step 9, enter the Subnet Mask.

Select [IPv4 – Gateway Address], and then [Change Settings].

NOTE: If you do not wish to set the gateway address, leave this field blank.

Using the same method as in step 9, enter the Gateway Address.

Select [IPv4 – IP Filter], and then [Change Settings].

Select [Enabled] to filter access to the machine.

NOTE: If you do not wish to use the IP filter feature, select [Disabled].

NOTE: Use CentreWare Internet Services to register the IP addresses which are not 
allowed to access the machine. 

When you have finished establishing TCP/IP, select [Close] on the [Protocol 
Settings] screen.

Set [IPv6 Address Manual Configuration].

NOTE: Select [Enabled] when the machine is connected to a network on which IPv6 
stateless address autoconfiguration is disabled, or when you want to set a static IPv6 
address.

If you selected [Enabled] in step 6, proceed to step 7. Otherwise, proceed to step 13.