Xerox 7232 User Manual

Select [Enabled] to filter access to the machine.

NOTE: If you do not wish to use the IP filter feature, select [Disabled].

NOTE: Use CentreWare Internet Services to register the IP addresses which are not 
allowed to access the machine. 

When you have finished establishing TCP/IP, select [Close] on the [Protocol 
Settings] screen.

Set [IPv6 Address Manual Configuration].

NOTE: Select [Enabled] when the machine is connected to a network on which IPv6 
stateless address autoconfiguration is disabled, or when you want to set a static IPv6 
address.

If you selected [Enabled] in step 8, proceed to step 9. Otherwise, proceed to step 15.

Select [IPv6 – Manual IP Address Setup], and then [Change Settings].

Use the keypad on the screen to enter the IP Address for the machine in the 
format “xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx”. Select [Save].

Select [Manually Configured IPv6 Prefix], and then [Change Settings].

Set the IP address prefix, and then select [Save].

Select [IPv6 – Manual Gateway Setup], and then [Change Settings].

Using the same method as in step 10, set the gateway address.

Select [IPv6 – IP Filter], and then select [Enabled] or [Disabled].

NOTE: If you do not wish to use the IP filter feature, select [Disabled].

NOTE: Use CentreWare Internet Services to register the IP addresses which are not 
allowed to access the machine. 

When you have finished establishing TCP/IP, select [Close] on the [Protocol 
Settings] screen.

This section explains how to set up Solaris, SunOS, and HP-UX workstations. Refer to 
the relevant instructions below.

Solaris – page 88
SunOS – page 89
HP-UX – page 90

A printer name for the logical printer should correspond to the print language/mode to 
be used for printing, or to the Logical Printer Number which was registered through 
CentreWare Internet Services.