Xerox X12 User Manual
Page 7
Part number: 45022476
5.
Select the paper size that is loaded in the tray from the Media Size pull-down menu.
The Tray Alignment is specific to the combination of tray and paper size. If you align Tray 1
with Letter paper and then load Legal paper in Tray 1, the alignment will be invalid. You
must perform a new Tray Alignment for each combination of tray and paper size.
with Letter paper and then load Legal paper in Tray 1, the alignment will be invalid. You
must perform a new Tray Alignment for each combination of tray and paper size.
6.
In the Print alignment page section, select the check box to print a duplex page and see
the instructions on the test sheet.
the instructions on the test sheet.
7.
Select and print the alignment page.
8.
Once the page has been printed, follow the directions on the alignment page.
9.
Fold the page in half horizontally, unfold it, and fold it in half vertically.
When you unfold the sheet again, notice the fold lines cross three scales on three sides of
the page. Determine the number where the fold line crosses each scale.
the page. Determine the number where the fold line crosses each scale.
10.
In the “Enter alignment values” section, type in the value where the fold crosses each of
the three scales, marked A, B, and C, for Side 1.
the three scales, marked A, B, and C, for Side 1.
To align for duplex printing, also enter the values for the three scales on Side 2 of the page.
11.
After you have entered all of the alignment values, click Apply.
12.
To remove the alignments, select a tray and click Defaults in the “Enter alignment values”
section.
section.
13.
Click Done when you have finished.
N
OTE
:
If the alignment results are not correct, repeat the steps and see the instructions in
the alignment test data.
Increase in imageable area
This feature increases the imageable area for paper sizes SRA3 (320 mm
x
450 mm) and
12"
x
18" (305 mm
x
457 mm). The expanded imageable area is automatically available
when you select either of these paper sizes. You will notice a smaller margin on output
compared to software version 1.1.
compared to software version 1.1.
The margins supported for 12"
x
18" are 3mm on all edges. The margins supported for
SRA3 are 3 mm on the top and the bottom edges, and 9 mm on the left and right edges.
This feature is available after you load the new printer files on your Windows and/or Mac
operating system. Use the Installer WebTool to download the printer files.
operating system. Use the Installer WebTool to download the printer files.