Xerox 701P42722_EN User Manual

This section describes the installation procedures to use the machine in a NetWare 
environment.

The installation procedure is as follows.

For more information, refer to Network Communication Setup on page 35.

For more information, refer to NetWare Setup on page 37.

For more information, refer to Workstation Setup on page 37.

For more information, refer to Test Print on page 37.

Use this procedure to set up the network communication parameters of the machine.

At the machine, perform these steps.

NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP 
network.

NOTE: CentreWare Internet Services can also be used to configure the machine. 
Refer to CentreWare Internet Services chapter on page 91.

First, enable the NetWare port.

Connect the machine to the network.

Press the <Log In/Out> button.

Select [System Settings].

Enter the password using the numeric keypad and then select [Confirm].

Select [Print Settings] and then press the <Enter> button.

Press the <Enter> button on the [Network/Port] screen.

Select [NetWare] by selecting [

T] or [S] and then press the <Enter> button.

Select [Port Status] by selecting  [

T] or [S] and then press the <Enter> button.

Select [Enable] by selecting  [

T] or [S] and then press the <Enter> button.