Xerox 701P42722_EN User Manual

This section describes the installation procedure for using the machine on an SMB 
network.

The installation procedure is as follows.

When using NetBEUI:

Set the SMB port to [Enable] using the control panel or CentreWare Internet 
Services.

When using TCP/IP:

Set the SMB port to [Enable] using the control panel or CentreWare Internet 
Services. Set the IP address on the control panel.

Install the print driver on the computer.

A print job should be submitted to make sure that the machine has been installed and 
configured correctly.

This procedure is used to set up the network communication parameters of the 
machine.

At the machine, perform these steps.

NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP 
network.

NOTE: CentreWare Internet Services can also be used to configure the machine. 
Refer to CentreWare Internet Services chapter on page 91.

First, enable the SMB port.

Connect the machine to the network.

Press the <Log In/Out> button.

Select [System Settings].

Enter the password using the numeric keypad and then select [Confirm].

Select [Print Settings] and then press the <Enter> button.

Press the <Enter> button on the [Network/Port] screen.