Xerox 701P42722_EN User Manual

The machine can be connected directly to the parallel port of a host workstation. A 
document file can be sent from the host workstation via the parallel port to the machine 
for printing. Other workstations can be connected via a network to the host workstation. 
Each workstation has a queue that can hold a number of files.

The document file is sent from the queue in the workstation to the queue in the host 
workstation, and then onto the queue in the machine to be printed.

The following computers support printing through the parallel port.

•

Windows 95/Windows 98/Windows Me

•

Windows NT 4.0/Windows 2000/Windows XP/Windows Server 2003

Follow these procedures to install and use the machine on the parallel port.

There are three stages required to install the machine on a parallel port.

This requires the machine to be set up for parallel port printing.

This requires the workstation to be configured to print to the machine.

A print job should be submitted to make sure that the machine has been installed and 
configured correctly.

Connect the machine and the computer with an IEEE1284 Parallel Port Cable.

Insert the interface cable connector into the parallel interface connector of the 
machine and secure it using the wire clips on both sides.

Connect the other end of the interface cable connector to the computer.

Switch on the computer.