Xerox 701P42722_EN User Manual

NOTE: Use the DHCP server together with the Windows Internet Name Service 
(WINS) server.

If you selected [Manual] in step 4, use the following steps to enter the IP address.

If you selected other than [Manual], press the <Login/Out> button and then go to 
Workstation Setup on page 88. 

Press the <Exit> button.

Select [IP Address] by selecting  [

T] or [S] and then press the <Enter> button.

Use the numeric keypad to enter the IP address in the format “xxx.xxx.xxx.xxx”.

NOTE: Press the <

J> button to move to the next section. Press the <I> button to 

return to the previous section.

NOTE: You cannot enter 127, 254, or 255 into the first section of the format.

Press the <Enter> button.

Press the <Exit> button.

Use the same steps as IP address setting to enter the subnet mask and gateway 
address.

NOTE: You can enter 000, 128, 192, 224, 240, 248, 252, 254, or 255 into each section 
as the values for the subnet mask.

NOTE: You cannot enter 127, 254, or 255 into the first section of the format for the 
gateway address.

Press the <Log In/Out> button.

NOTE: If you wish to filter access to the machine from the client computers, activate 
the IP Filter. The [Filter] screen is located in the same layer as the [TCP/IP Settings] 
screen.

For each client workstation that will be sending print jobs to the machine, install the print 
drivers for the machine, and map to the machine as a printer. Refer to the HTML 
documentation in CentreWare Utilities CD-ROM, for additional information.

To make sure that the machine has been installed on the network correctly a test print 
should be submitted from a client workstation. Perform the following steps.

Open a document on a client workstation.

Select the machine as the printer to which the selected document will be sent.

Print the document on the machine and verify that it prints correctly.